- Send to a friend
-
- Remove this product from my favorite's list.
- Add this product to my list of favorites.
Pi-Puck Extension for e-puck 2
712,50 €
650,00 €
587,50 €
1 687,50 €
No products added yet
When you want astonishing results for less cost than many other brands - PrimaCreator VALUE resin should be your first choice!
Resin from VALUE line is a high-quality resin made from the best materials.
Your prints cures in sunlight or a UV curing chamber. When the curing is finished, the result is a rock-hard print with very small shrinkage.
The finished print is a solid colour part with a beautiful semi matte surface with excellent details and smooth layer transitions.
If you go for the transparent resin you will have a crystal-clear transparency which is truly stunning.
VALUE resin has many benefits over other brands of comparable resins.
The most noticeable is that it doesn´t smell very much.
Optimized for UV Lightsource 395 – 405 nm.
Fast curing time, 4 – 8 seconds per layer for quicker prints.
After printing clean you print in IPA (Isopropyl Alcohol) to rinse of extra resin left.
When it´s time for curing you can use sunlight or a uv curing chamber.
Depending on print the curing times can vary:
In a UV light curing chamber, it will take about 2-5 minutes.
In sunlight, 10-20 minutes.
In daylight on a cloudy day it can take up to 60 minutes.
UV Lightsource Wavelength: |
395 - 405 nm (optimal) |
Viscosity: |
100-150 (25℃ m.pa.s) |
Density: |
1.05 - 1.13g/cm³ |
Hardness |
85-88 Shore D |
Tensile strength: |
42.0 Mpa |
Flexural Strength: |
60 Mpa |
Storage temperature |
5 - 40℃ |