Kategorije

Košarica  

Nema proizvoda

0,00 € Dostava
0,00 € Porez
0,00 € Ukupno

Cijene uključuju PDV

Izvrši kupnju

Lista za Ponudu

Proizvod nije dodan

FAQ

Da li trebate pomoć Pogledajte našu sekciju sa FAQ

Promocije

Nema specijalnih ponuda u ovom trenutku.

CNC 2M542 Stepper Motor Driver Controller 4.5A Support Nema17/23/34

CNC 2M542 Stepper Motor Driver Controller 4.5A Support Nema17/23/34

Short Description : 

The M542 Stepper Driver Board Controller is a high performance microstepping driver based on pure-sinusoidal current control technology. 

Više detalja...

51,25 €

AB-20-019-209

Dostupno : Na Zalihi

Proizvod nije dodan

Secure payment
Secure payment

Detaljan Opis :

The M542 Stepper Driver Board Controller is a high performance microstepping driver based on pure-sinusoidal current control technology. With this technology and the self-adjustment technology (self-adjust current control parameters) for different motors, the drive motors can run with smaller noise, lower heating, smoother movement and have better performances at higher speed than most of the drivers in the markets. It is suitable for driving 2-phase and 4-phase hybrid stepping motors, so the Nema17--Nema34 stepper motors with a 1.0A-4.5A current will be suitable.

 

Značajke :

  • High performance, cost-effective
  • Supply voltage from 20V DC to 50V DC
  • Output current from 1.0A to 4.5A
  • Self-adjustment technology, full to half current self-adjustment when motors from work to standstill via switching off SW4
  • Pure-sinusoidal current control technology
  • Pulse input frequency up to 300 KHz
  • TTL compatible and optically isolated input
  • Automatic half-current reduction as long as switching off SW4 when motors stop
  • 16 selectable resolutions in decimal and binary, up to 51,200 steps/rev
  • Suitable for 2-phase and 4-phase motors
  • Support PUL/DIR and CW/CCW modes
  • Short-voltage, over-voltage, over-current and short-circuit protection, protect the PC, motors, driver etc from being damaged  


 
Primjena :

  • Suitable for any small-and-medium automatic equipment with CNC controller, such as  X-Y tables, labeling machines, laser cutters, engraving machines, and pick-place devices
  • Suitable for a wide range of stepping motors, from NEMA size 17 to 34 
  • For processing various pattern mould 
  • For advising, such as brand, architechture mould, badge, nameplate, display boards, doorplate, furniture decoration, etc. 
  • For carving portrait, scenery, handwriting, sealing, etc.


Sadrži u pakiranju :

  • 1x M542 CNC Stepper Motor Driver (1.0A-4.5A)

 

Dokumenti :

ST-M5045 Instruction manual.pdf

Put: > > > > CNC 2M542 Stepper Motor Driver Controller 4.5A Support Nema17/23/34

29 ostali proizvodi u istoj kategoriji